Building Installation; Attaching The Antenna - Wilson Electronics Sleek 2B5225 Mode D'emploi

Building Installation

Installing a Wilson electronics Outside Antenna in a Building
Follow the specific antenna instructions included with the outside antenna (sold separately except for
certain kits). These instructions assume that you are using a Wilson Electronics Mini-Magnet Mount
Antenna and the optional suction-cup window bracket.
To receive the best signal, select a window on the side of your building where your outside signal is
the strongest.
Attach the suction-cup bracket to the inside of a window so that the cable will reach
the location of the Sleek. Place the bracket as high on the window as possible for
best performance.
Once the bracket is in place, attach the magnet base of the antenna to the flat
surface of the bracket. Note: The antenna must be installed vertically. Signal
performance will be degraded if the antenna is not vertical.
Installing the Wilson Sleek Signal Booster in a Building
The Wilson Electronics Sleek may be placed in any convenient indoor location, such as a desk or
tabletop. The cell phone must be in the cradle and a Bluetooth

Attaching the Antenna

Once you have selected the location for the Sleek, run the cable from the outside antenna and attach it
to the SMA connector on the bottom of the Sleek.
Note: The Sleek and the outside antenna must have a minimum separation of 3 feet to prevent oscillation.
Note: The cell phone must be placed in the Sleek cradle to amplify properly.
5 5
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
® headset used for voice communications.