Indicator Light Chart; Cleaning; Maintenance; Troubleshooting - Munchkin 59S Notice D'utilisation

How to Use

INDICATOR LIGHT CHART

Indicator Light
Blinking White
No Light
Indicator Light /
Power Button
Charging / Battery
Indicator Light
(Next to USB port)
Indicator Light
Blinking Red
Blinking White
Solid White
12
Mode
Disinfecting in progress
Sleeping (Off)
Mode
Low Battery
Blinks about 15 seconds
Recharging
Fully Recharged
(power plug-in)

CLEANING

This device is not waterproof. Do not immerse in water.
To clean, wipe surface of unit with a towel. Remove any water droplets to prevent
moisture from damaging unit's circuitry.
Between use or while carrying it during travel, please put this product into storage
bag to prevent dust contamination and to protect surface from abrasion.

MAINTENANCE

Product service should be performed by an authorized service representative.

TROUBLESHOOTING

1. If the power button does not respond or the unit will not turn on:
(A) Plug into power source via USB cable to recharge.
(B) Check if USB cable is connected properly to the power source. Remove the
cable and re-insert securely into the port.
(C) If the internal circuit is damaged, the unit must be returned to Munchkin for
after-sales service.
2. The UVC light will not shut off after the lid is opened:
(A) Check if either one of
the upper cover detection
switch is dirty. Wipe it
clean with a cloth.
(B) Check if either one of the
safety pin is broken.
(C) If either one of the upper
cover detection switch is
broken or the internal
circuit is damaged, the unit
must be returned for
after-sales service.
How to Use
Upper Cover
Detection
Switches
Safety Pins
13