Allmatic KAIROS S Manuel D'instructions page 4

1
DESCRIPTION
The device can work only combined with an Allmatic control unit.
This device must be installed where it can detect the presence of wind, therefore not in places shielded by
walls or protrusions. For the connections it is not necessary to observe any polarity; in any case it is advisable
to follow the technical instructions of the control unit
2
ASSEMBLING AND CONNECTIONS
The assembling happens in stages:
1. Fix on the wall the plate using the drilling plan at
pag.7 at least 2 meters from the earth
2. Apply the seal, by passing the cable through the
hole
3. Connect the cable to the terminals of the sensor
4. Screw the sensor to the wall plate
5. Cover with the shells
6. Adjust the angle so that the blades rotate
horizontally, screw the socket head screw and
close with the cap provided
120°
120° 120°
5
4
6
WEEE - INFORMATION FOR USERS
2
3
If the crossed-out bin symbol appears on the equipment or packaging, this means the product must not be included with other general
waste at the end of its working life. The user must take the worn product to a sorted waste center, or return it to the retailer when
purchasing a new one. Products for disposal can be consigned free of charge (without any new purchase obligation) to retailers with
a sales area of at least 400 m
disposal of the used device, or its subsequent recycling, helps avoid the potential negative effects on the environment and people's
health, and encourages the re-use and/or recycling of the construction materials.
GUARANTEE
In compliance with legislation, the manufacturer's guarantee is valid from the date stamped on the product and is restricted to the repair or free
replacement of the parts accepted by the manufacturer as being defective due to poor quality materials or manufacturing defects. The guarantee
does not cover damage or defects caused by external agents, faulty maintenance, overloading, natural wear and tear, choice of incorrect product,
assembly errors, or any other cause not imputable to the manufacturer. Products that have been misused will not be guaranteed or repaired.
Printed specifications are only indicative. The manufacturer does not accept any responsibility for range reductions or malfunctions caused by
environmental interference. The manufacturer's responsibility for damage caused to persons resulting from accidents of any nature caused by our
defective products, are only those responsibilities that come under Italian law.
4/8
Fixing examples:
, if they measure less than 25 cm. An efficient sorted waste collection for the environmentally friendly
2
ITA ENG
1 2
3
6
FRA ESP
6-1622650
5
4
6
rev.3 07/12/2022