First Time Installation; Program Edit - SOUNDMASTER PDB1910 Mode D'emploi

Connect the supplied antenna to the antenna socket on the right side of the device. Set the
antenna upright.

FIRST TIME INSTALLATION

After all connections have been made properly, switch on the unit. Press "INPUT" and select
with " CH+" the function "DTV". Confirm the selection with "OK". If you are using the
CH- /
function for the first time or restored to factory default, the install menu will appear on the
display.
1. Select the "OSD Language" with "
2. Choose the "Country" with "
3. The unit starts the automatic scan. During the scan the display show a slide bar that
indicate the process of the scan and a number of stations that have been found.
4. When the scan is complete, you are now ready to watch TV.
ATTENTION! With this device, only free-to-air programs can be played! If no or only a few
stations are found, this can have several causes:
➢ Bad reception. Move the antenna or the complete device to another location and restart the
search.
➢ The connected antenna is not sufficient for the current reception range of the device.
Connect an outdoor or roof antenna to the device.
➢ In the current reception area, no DVB-T2 reception is possible.
➢ Do not place the device or the antenna in the vicinity of possible sources of interference,
e.g. microwaves, refrigerators, etc.
For further information and the receivability of the transmitters, please contact the provider of
the respective country (for example
SELECT A STATION
To select a TV channel, press the buttons "
control, or use the number buttons 0-9 on the remote control to directly select the channel
position.

PROGRAM EDIT

To edit your program preferences (lock, skip, favourite, move or delete), you must enter the
DVB-T2 menu with "DTV/MENU". Select the point "Channel" and press the "
the function "Programme Edit" and press "OK".
Move TV or Radio program
1. Select the preferred program. Then press the YELLOW button. A move symbol will appear.
2. Press " " to move the program.
3. Press "OK" to confirm.
4. Repeat the above steps to move more channels.
DVB-T2
" and press "OK" to confirm the language.
" and confirm again with "OK".
www.dvb-t2hd.de for Germany).
CH- / CH+" on the unit or on the remote
5
PDB1910 / English Instruction Manual
" button. Choose