• Read, understand and follow all warnings and instructions before using this product. Failure to follow these directions
may result in property damage, serious bodily injury, and/or death. Cequent Performance Products is not responsible for
any property damage, personal injury, or death occurred while using any ROLA products. Retain these instructions for
future reference.
• Any modification or unintended use of this product voids any warranty and could create a hazardous condition.
• Loads must be secure according to local height and identification regulations and or laws.
• Secured loads and connections must be re-checked periodically for tightness.
Features:
Can be used on most truck racks
No drilling required
Cast Aluminum door and end cap
Stainless Steel hardware
Spring loaded door latch
Urethane gasket for weather resistance
ITEM
DESCRIPTION
1
U-BOLT 3/8-16 SS
2
STEEL PLATE
3
3/8-16 LOCKNUT
4
#8 X 5/8 TAPPING SCREW
5
DOOR ASSEMBLY
6
6
END CAP
END CAP
Step 1: Place door and cap on 6" PVC pipe and secure by inserting 4 self-tapping screws in the pre-drilled locations at each end.
Optional: Substitute pop rivets for the self-tapping screws for higher security.
Step 2: Place the conduit carrier on the rack. Place the steel plates below the truck rack cross bar. Place the U-bolts over the PVC
pipe in front and behind the cross bar and through the steel plates. Secure with the provided lock nuts.
Tips: The door latch handle tension can be adjusted by tightening or loosening the lock nut on the back side of the door assembly.
The door can be locked with up to a ½" diameter lock.
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
Product Name:
WARNING!
QTY.
4
4
8
8
1
1
1
6" PVC PIPE
TRUCK / VAN RACK CROSSBARS
Conduit Carrier
Product Code:
59797
Required for Assembly:
9/16" Wrench
5/16" Nut Driver
6" schedule 40 or 80 PVC pipe
(Length to Suit)
59797N Rev B
2-4-14
Printed in China