Drinkwell Platinum Mode D'emploi page 6

2) Thread the plug through the opening next to the motor. Under the arch
you can tuck the cord into "cord channels", then thread the cord along
the back of the fountain to the cord notch (Fig. 3d). Use this pass-through
to keep the cord from showing.
3) Line up the filter housing unit over the motor and then the bowl. You will
want to line up the intake tube to fit directly into the motor. Once in place,
gently push down, locking the filter housing into place. (Fig. 3f)
)
4 Replace the pre-filter over the flow
control knob by sliding the narrow end in
first. The lip on the top of the pre-filter will
be facing the front of the fountain, push
down to snap it into place over the flow
control knob.
5) Replace the filter and lid (See Operating
Instructions #5 & 7)
6) Replace the reservoir (See Operating
Instructions #8)
www.petfountain.com
Fig. 3c
Intake Tube
Fig. 3e
Cord Channels
Cord Pass-Through
Fig. 3d
Fig. 3f
Fig. 3g
p. 6