Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
MATERIALS
A
1
Cross Bar
B
1
Side Arms
C
1
M12 x 35mm x 1.75mm Bolts, Flat Washers, Lock Washers, Witter Cage Nuts and Retainers.
D
1
M12 x 35mm x 1.75mm Bolts, and Serrated Flange Nuts
ZE
1
Retractable Electrical Plate.
ZN
1
Neck Kit
FITTING
1.
Remove wheel arch clips and partly pull away wheel arch edge trim to reveal screw to be removed also.
2.
Remove bumper (Clips/screws along bottom edge, pull tips away from vehicle to unclip).
3.
Remove Inner steel bumper beam.
4.
Pre-Assemble the Witter Cage Nuts to each Side Arm (B). - note which side of each Side Arm to assemble to.
5.
Insert each Side Arm (B) into each chassis rail and loosely secure using remaining fasteners (C).
6.
Assemble Cross Bar (A) to Side Arms (B) using fasteners (D).
7.
Assemble the chosen Neck Kit (ZN) and Electrical Plate Kit (ZE) to Cross Bar (A) using separate fitting instructions.
8.
Cut bumper and refit to vehicle
9.
Fully Tighten all fasteners.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
Fitting
Instructions
µW0001F165U-FIT$011302190000&Ä
W0001F165U-FIT$011302190000
TOWBAR
For Ford Kuga 2008-
Incl. 2013- models
F165U
Publicité
Manuels Connexes pour Witter F165U
Sommaire des Matières pour Witter F165U
- Page 1 Remove Inner steel bumper beam. Pre-Assemble the Witter Cage Nuts to each Side Arm (B). - note which side of each Side Arm to assemble to. Insert each Side Arm (B) into each chassis rail and loosely secure using remaining fasteners (C).
- Page 2 Notices de ATTELAGE F165U Pour Ford Kuga 2008- Montage Et modèles à partir de 2013- MATERIELS Traverse principale Bras latéraux Boulons M12 x 35mm x 1.75mm, rondelles plates, rondelles freins, écrous prisonnier. Boulons M12 x 35mm x 1.75mm et écrous a collerette...