Bosch GAS 35 L SFC+ Professional Notice Originale page 18

OBJ_BUCH-1702-002.book Page 18 Thursday, July 25, 2013 3:30 PM
18 | English
12 Castor
13 Cable holder
14 Locking latch of filter cover
15 Holder for vacuum tubes
16 Holder for crevice nozzle/elbow
17 Holder for floor nozzle
18 SFC+ switch
19 Tool sleeve
20 SFC+ module
21 Vacuum hose
22 Elbow
23 Disposal bag
24 Flat-fold filter(cellulose)
25 Crevice nozzle
26 Rubber lip
27 Brush insert
28 Floor nozzle
29 Vacuum tube
30 Retainer for vacuum-hose holder
31 Snap-fastener
32 Air diffuser
33 Filter-cleaning actuator
34 Filter cover
35 Level sensors
Accessories shown or described are not part of the standard deliv-
ery scope of the product. A complete overview of accessories can
be found in our accessories program.
Technical Data
Wet/dry vacuum cleaner
Article number
Rated power input
Frequency
Container volume (gross)
Net volume (for fluids)
Dust bag contents
Max. vacuum*
– Vacuum cleaner
– Turbine
Max. flow rate*
– Vacuum cleaner
– Turbine
Max. vacuum capacity
Surface of flat-fold filter
Dust category
Weight according to
EPTA-Procedure 01/2003
Protection class
Degree of protection
Ø
* Measured with a 35 mm and 3 m long vacuum hose
The values given are valid for nominal voltages [U] of 230 V. For lower
voltage and models for specific countries, these values can vary.
1 609 92A 0E0 | (25.7.13)
Automatic Start/Stop feature*
EU
UK
UK/DK
CH
* Specification of the allowable load of the connected power tool (coun-
try-specific)
Noise Information
Measured sound values determined according to EN 60704.
Typically the A-weighted sound pressure level of the vacuum
cleaner is lower than 70 dB(A). Uncertainty K= 3 dB.
The noise level when working can exceed 80 dB(A).
Wear hearing protection!
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under "Technical data" is in conformity with the fol-
lowing standards or standardization documents: EN 60335
and the directives 2011/65/EU, 2006/42/EC,
2004/108/EC including their amendments.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen
Henk Becker
Executive Vice President
Engineering
GAS 35 L SFC+
3 601 JC3 0..
W 1200
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Hz 50/60
Leinfelden, 25.07.2013
l 35
Assembly
l 19
l 19
 Before any work on the vacuum cleaner itself, pull the
mains plug.
230
hPa
Mounting the Vacuum-hose Holder (see figure A)
hPa 254
– Slide the vacuum-hose holders 4 firmly from above into the
36
l/s retainers 30 intended for this purpose, until they engage.
l/s 74
Mounting the Vacuum Hose (see figure B)
W 1380
– Mount the vacuum hose 21 onto the hose connection
2
m 0.615
piece 2 and turn it in clockwise direction to the stop.
L
Note: While vacuuming, an electrostatic charge develops in
the vacuum hose and accessories caused through the friction
kg 12.2
of the dust, which the operator could experience in the form
/I
of static discharging (dependent on environmental influences
and physical perception).
IP X4
As a general rule, Bosch recommends using an anti-static vac-
uum hose (accessory), when vacuuming fine dusts and dry
materials.
max. power
Rated voltage output
220 –240 V 2200 W
110 V 750 W
240/230 V 1800 W
230 V 1100 W
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Bosch Power Tools
min. power
output
100 W
100 W
100 W
100 W