Side Panel - Intellinet Network Solutions 508346 V2 Instructions

Side Panel

A—Grounding
ATTENTION: When installing unit, connect the chassis ground first; when uninstalling unit, disconnect chassis ground last.
Wire the grounding terminal to an earth grounding object to protect equipment from external electrical surges.
B—Terminal Block Installation
NOTE: Ensure all power is off/disconnected before beginning!
1 Loosen appropriate screws. Insert bare power-supply wires into appropriate terminal
slots (positive wire into positive slot; negative wire into negative slot).
2 Tighten appropriate screws to secure wires.
3 Install block into the device and tighten screws.
C—DIP Switch
Placement
Desktop Installation
Prior to use, place/position the device:
• on a level surface with at least 25 mm (approx. 1") of clearance for ventilation;
• away from sources of electrical noise: radios, transmitters, broadband amplifiers;
• within 100 m (approx. 328') of network devices it's to be connected to.
DIN-Rail Installation
1 Angle spring of mounting clip over top lip of DIN rail.
2 Push device down till clip clicks onto rail.
3 Ensure installation is stable.
C B
1 2
+
-
-
+
Switch Position
On Enable port isolation
1-I/R
Port Isolation
Off Turn off port isolation
On Enable VLAN Isolation
2-VLAN
VLAN Isolation
Off Turn off VLAN Isolation
On Enable QOS function
3-Q/I
QOS
Off Turn off QOS function
On Enable flow control
4-F/P
Flow Control
Off Turn off flow control
Instructions
A
3
PWR1/PWR2 INPUT:DC10V-58V
P1+ P1/2- P2+
PWR1 PWR2
Description
2
1
3
English 3