Sauder Litter Box Credenza Mode D'emploi page 16

Step 12
Insert the USB POWER HUB (9D) into the large hole in the RIGHT
å
END (A). An opening has been provided through the LARGE
BACK (F) for cord access.
Using your hammer, gently tap a CAM COVER (72P) onto each
å
visible HIDDEN CAM.
To cover HIDDEN CAMS
72P
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
"Changes or modifi cations not expressly approved by the party responsible for compliance could void the user' s authority to operate this device".
OR
"Changes or modifi cations not expressly approved by Sauder Woodworking Co. could void the user's authority to operate this device".
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Page 16
(18 used)
425539
Go on, spoil ' e m a little.
F
A
www.litterbox.com/support
9D