8880965
ASSEMBLY & INSTALLATION
INSTALL AIR HOSE
Make sure the air hose's coupling style and diameter matches your equipment.
Adapters may be used as needed (sold separately) .
1.
Locate the male air outlet valve or connector on the equipment.
2.
Wrap the external threads of the valve or connector with sealant tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading threads unwrapped
for easier alignment.
3.
Check that the hose's o-ring is seated properly in the female connector.
4.
Screw the air hose's female connector onto the outlet valve. Tighten with
a wrench.
5.
Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
6.
Follow the air tool's instructions for installing a coupler on the other end.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components.. Only use identical replacement parts when servicing.
3.
Only use accessories intended for use with this tool. Follow instructions
for changing accessories.
4.
Keep the tool handles or gripping surfaces clean and dry.
5.
Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
www.princessauto.com / 1-800-665-8685
HAND-CRANK SWIVEL AIR HOSE REEL
V1.0
Page 6