Control Panel; Using Your Coffee Maker - Robusta PURA COFFEE 1.5L Manuel D'utilisation

USAGE
Verify that no accessories are missing and that the appliance is not damaged. Pour water into the water
container up to the maximum level and move the water around several times without adding ground coffee.
Then discard the water. Thoroughly clean all the detachable parts with hot water.

USING YOUR COFFEE MAKER

1. Open the lid of the water tank and fill it with cold drinking water. The water level must not exceed the
maximum level indicated by the water level indicator.
2. Place the filter holder in its receptacle and make sure it is assembled correctly. Then place the paper filter
inside the filter holder, making sure it is properly in place.
3. Place ground coffee in the paper filter. A cup of coffee generally requires a level spoonful of ground
coffee, but the quantities can be changed according to preference.
4. Insert the stainless steel carafe flat on the heating plate.
5. Plug the power cable into a mains socket. The screen will display «12:00» and the colon in the middle
will flash, but the LEDs will not light up.
6. Press the on/off button and the indicator light RUN (ON) will illuminate red. The appliance will start.
Note: This appliance has a function for adjusting the strength of your coffee. If you would like your coffee
to have a stronger taste, hold down the on/off button for 4 seconds to start making your coffee. The LED
will flash constantly until the process has finished.
7. The preparation cycle can be interrupted by pressing the on/off button at any time of the preparation.
The RUN light (ON) will switch off. The appliance will continue the preparation cycle when you press the
on/off button again.
1. Porte-filtre
2. Anti-drip
3. Top lid
4. Water tank
5. Product

6. Control panel

7. Stainless steel carafe
CONTROL PANEL
9
EN