Cleaning And Maintenance - Robusta PURA COFFEE 1.5L Manuel D'utilisation

EN
Note: You can remove the carafe and serve the coffee at any time. The flow of coffee will stop automatical-
ly. However, this pause must not exceed 30 seconds.
8. Remove the carafe to serve once the preparation is completed (approximately one inute after the coffee
stops flowing out).
Note: The quantity of coffee obtained is less than the amount of water poured in the tank, because a
portion of the water is absorbed by the ground coffee.
9. Always switch off the coffee maker and unplug it when it is not in use.
Note: Be careful when pouring the coffee to avoid burning yourself, because the coffee is very hot when it
has just been prepared.
AUTOMATIC START FUNCTION
If you do not wish to start an immediate preparation cycle, for
example, the time shows 17:10 and you want the coffee maker
to start automatically at 20:15, first follow steps 1 to 5 of the
above section and then adjust the automatic start function as
follows:
1. Press once on the Set Delayed Start button prog and the
word CLOCK appears in the top right of the screen.
2. Keep pressing the button for the hour and minutes to adjust
the current time (real time), specifically 17:10 (see Image 1).
Note: the time system is 24-hour clock.
3. Press again on the Set Delayed Start button prog and the word
TIMER appears in the top left of the screen.
4. Adjust the delayed start time by pressing the Hour and Minute
button several times until 20:15 is obtained (see Image 2).
5. Press the on/off button twice and the AUTO LED will light up.
The screen will display the current time. You can display the automatic
start-up time by pressing prog (set delayed start).
Note: You can cancel auto mode by pressing the on/off button
once to turn the appliance off, or press the on/off button twice to start preparing your coffee
immediately. If you want to change the time for auto start, follow only steps 1 to
5 above.
At the scheduled time, the AUTO will turn off and the RUN light will turn green and the appliance will begin
the preparation. The appliance will switch off automatically after two hours if it is not manually turned off
once preparation has finished.

CLEANING AND MAINTENANCE

WARNING: Unplug this appliance before cleaning it. To protect yourself against the risk of electric shock,
never immerse the appliance, its power cord or its plug in water or any other liquid.
After each use, always ensure that the plug is first disconnected from the wall socket.
1. Clean all detachable parts after each use with hot, soapy water, and rinse in cold water. Do not wash
parts in a dishwasher.
2. Wipe the external surface of the product with a damp, soft cloth to remove marks.
3. Drops of water can accumulate in the area above the filter holder and flow onto the base
of the product during the preparation. To control this, wipe this area with a clean, dry cloth after each use
of the appliance.
4. Never use an abrasive agent to clean it.
5. Put all parts back together and keep them for the next use.
10