Publicité
Les langues disponibles
Les langues disponibles
Installing Grill on custom built cabinet
Layout for Non-combustible enclosure
Configuration Example 1: With closed cutout bottom
MINIMUM 20 SQ IN (130 SQ
CM) OF VENTILATION
REQUIRED.
MINIMUM 10 SQ IN (65 SQ CM)
OF VENTILATION REQUIRED
WARNING
•
The upper vent opening must be at least 20
square inches for a 20 lb propane cylinder.
•
The lower vent opening must be at least 10
square inches for a 20 lb propane cylinder.
WARNING
A propane tank can not be stored
below the gas grill. Only 1 max 20 lbs
(12.125in x 17.75in) tank in service
should be used with the Grill.
Propane tank must be secured to the built-in
cabinet inside the cylinder enclosure.
10in
10in
1in
Back View
ELECTRICAL OPENING
GAS INLET OPENING
MINIMUM 20 SQ IN (130 SQ
CM) OF VENTILATION
REQUIRED ON EACH END OF
CABINET.
5"
127mm
MAXIMUM
MINIMUM 10 SQ IN (65 SQ CM)
OF VENTILATION REQUIRED ON
EACH END OF CABINET.
NOTE: The cabinet should not be designed in a way that a spare
cylinder can be stored inside the enclosure.
The opening of propane enclosure is limited to the dimensions below:
Width (W1) must be less than 23.5".
Height (H1) must be less than 18.5".
33" Grill
36" Grill
40" Grill
Side
Burner
NOTE: These illustrations are for reference purpose
only. Actual built-in cabinets and installation may
differ.
Min 4"
3"
H
3"
D
7.5"
2.4"
2.8"
2.4"
5"
127mm
MAXIMUM
H1
1"
25.4mm
MAXIMUM
Cutout Dimensions
SKU
W
66980
31.5"
66990
66981
34.5
66991
66982
38.5"
66992
66983
15.3"
66993
1.19"
0.78"
36"
915mm
RECOMMENDED
W
W1
D
H
22.3"
11.2"
22.3"
11.2"
22.3"
11.2"
22.4"
11.3"
17
Publicité
