Kohler K-72218 Guide D'installation Et D'entretien page 8

Sensor
Handle Switch
Apply grease.
4. Connect the Wires
Apply grease (provided) to the sensor socket located on the
circuit board inside the cover. This will provide additional
corrosion protection.
Connect the handle switch and sensor wires from the faucet to
the circuit board.
Connect the power cord to the circuit board.
Connect the solenoid wire to the circuit board.
Plug the power cord into an unswitched 120 VAC outlet. The
power LED on the circuit board will illuminate.
Test activation of the sensor. Refer to the "Faucet Operation"
section.
1276182-2-C
Power
LED
Power Cord
Solenoid
8
Cover
Solenoid
Kohler Co.