Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1.7 Front/Rear Panel Explanations
On the front panel You can found 2 LED for an easy diagnostic.
LED/Switch
1
2
3
Main Switch (4)
Information
AC input
Backup Outlets: 3 pcs Schuko
Input Circuit Breaker
To Control on/off the UPS when Utility is normal. Push
the "Main Switch" for 3 seconds, then release it.
To enable "DC-Start" Function when Utility fails. (To
enable DC Start properly, you are recommended to
connect <80% output load with the UPS only). P.S.
Make sure the computer connected to the UPS is
switched on before enable the "DC-Start" function.
25
ENG
Publicité
Table des Matières
