Connect The Loads - Atlantis Onepower 700 Mode D'emploi

The unit can be mounted to a wall surface. Please follow below steps:
Use a sharp nail to puncture the center of the two holes (128mm) to mark the

wall.
Mount the unit by positioning the key-hole slots over the mounting nails. (see

chart

1.5 Connect the loads

First, connect the UPS with the AC Mains, then plug the loads into the output
connectors on the rear of the UPS (there are 2 IEC). To use the UPS as a master
"On/Off" switch, make sure that all of the loads are switch "On".
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best
results, suggest to charge the battery at least 8 hours
before initial use. The unit charges its battery while
connecting to the utility.
22
ENG