Max 71953 Manuel D'instructions page 34

Fitting a disc
Press and hold down the spindle lock (1) to
secure the spindle. Turn the spindle until it
locks. Remove the � anges using the spanner
provided.
Fit the inner � ange and the required disc on
the spindle and screw the outer � ange back
on the spindle.
Turn the � anges so that they match the
thickness of the washer.
For thick washers, the edges of the � anges
should face in towards one another.
34
For thin washers, the outer edge of the � ange
should face away from the inner � ange.
Release the spindle lock.
Switch the angle grinder on and let it run
for 30 seconds to check that it is working
correctly and that there are no abnormal
vibrations.
Stop the angle grinder immediately if heavy
vibration occurs, and investigate the cause.
Use
Connect to mains electricity.
Take hold of the handle (3) and the support
handle (2). Press the on/off button (5) and
then push it forward to turn the angle
grinder on.
Avoid blocking the vent holes with your
hand, as this may cause the grinder to
overheat. Allow the disc to reach full speed.