Sauder HomePlus Collection 411963 Mode D'emploi page 10

Step 6
Fasten three HINGES (M) to each DOOR (F) as shown in the upper diagram below. Use twelve BLACK 1/2" FLAT
å
HEAD SCREWS (Z).
Carefully stand your unit upright as shown in the lower diagram.
å
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the lower
å
diagram. If it isn't, loosen the mounting screw to slide it against the stops. Then tighten the mounting screw.
Fasten a DOOR (F) to the LEFT END (B). Use the screws in the HINGES. See the next step for adjustments.
å
Fasten a PULL (N) to the DOOR (F). Use two BLACK 7/8" MACHINE SCREWS (W).
å
Repeat this step for the other door.
å
Adjusting
screw
M
Mounting
screw
BLACK 1/2" FLAT HEAD SCREW
(12 used for the HINGES)
W
BLACK 7/8" MACHINE SCREW
(4 used for the PULLS)
Page 10
F
F
Z
N
Stop
Mounting
screw
Hinge
411963
Mounting
screw
Adjusting
screw
M
B
F
www.sauder.com/services