Intec 23402 Manuel D'utilisation Et D'entretien page 17

EN EN
THE RAMS FAIL T THE RAMS F AIL TO GO BACK IN COMPLETEL O GO BACK IN COMPLETELY EVEN WITH THE CONTROLS IN DESCENT
POSITION. POSITION.
Check the suction-pump
- Check the head, POS. 19 - A00423 POS. 19 - A00423
OIL LEAKS FROM THE SILENCER OIL LEAKS FROM THE SILENCER
- Check that the pumping element
- Check that the seals,
OIL LEAKS FROM THE SUCTION PUMP OIL LEAKS FROM THE SUCTION PUMP
1. Check the quantity of oil in the tank, (see the "Oil level check" procedure in the "Maintenance for the end user"
section). If too much oil has been put in the jack, it will stop leaking very soon.
2. Check that the jack has been used observing the conditions listed previously, i.e. horizontally and not slanted. If the
jack has been turned upside down or tipped over, it will stop leaking very soon.
THE PIST THE PISTONS ARE VER ONS ARE VERY SLOW T
- Check that the tap, POS. 9 A00542 POS. 9 A00542
POS. 22 - A00423 POS. 22 - A00423 : remove it and clean it thoroughly.
, remove it and clean it thoroughly.
POS. 3 - A00423 POS. 3 - A00423
POS. 11 - A00423 POS. 11 - A00423
POS. 5, 9 - A00423 POS. 5, 9 - A00423 are not worn. If they are, replace them.
Y SLOW TO MOVE UP O MOVE UP
, located between the tank and motor pump is open.
Y EVEN WITH THE CONTROLS IN DESCENT
is not scored or damaged. If it is, replace it.
POS. 22 - A00423 POS. 22 - A00423
17