Product Certification Information; Components Requiring Periodic Replacement - RainSoft Ultrefiner II Mode D'emploi

Product Certification Information

Models Ultrefiner II - FMV - BNFP, Ultrefiner II - FMV - BNFV,
Ultrefiner II - FMV - CHFP and Ultrefiner II - FMV - CHFV conform to
NSF/ANSI 58, 42 and 401 for the specific performance claims as verified
and substantiated by test data. See performance data sheets for
specific reduction claims.
Models Ultrefiner II - FMV - BNFP, Ultrefiner II - FMV - BNFV,
Ultrefiner II - FMV - CHFP and Ultrefiner II - FMV - CHFV conform to
NSF/ANSI 58 for VOC reduction. See performance data sheets for
individual contaminants and reduction performance.
Models ULTREFINER II-FMV-BNFP, ULTREFINER II-FMV-BNFV,
ULTREFINER II-FMV-CHFP and ULTREFINER II-FMV-CHFV are
tested and certified by NSF International to CSA B483.1 Standard.
The compounds certified under NSF/ANSI 401 have been deemed as
"incidental contaminants/emerging compounds". Incidental contami-
nants are those compounds that have been detected in drinking water
supplies at trace levels. While occurring at only trace levels, these
compounds can affect the public acceptance/perception of drinking water
quality.
CALIFORNIA RESIDENTS: Water treatment devices sold to retail
consumers in California, accompanied by certain health claims, must be
registered by California State Water Resources Control Board. The
product accompanied by this manual is not certified in the State of
California for the purpose of making health claims. Please ask your dealer
about California certified models.
Components Requiring Periodic
Replacement
Pre-filter
The pre-filter reduces chlorine and removes most particles and sediment
as small as 10 microns in size from the water supply. The pre-filter requires
periodic replacement every 12 months after installation. Your water
quality and water usage may affect this replacement schedule. Please refer
to the chart on page 14 for replacement part numbers.
Ultrefiner II Membrane Cartridge
The Ultrefiner II membrane cartridge is a spiral wound, semi-permeable
membrane that requires periodic replacement approximately every 24 to
36 months after installation. Your water quality and water usage may affect
this replacement schedule. A water test for TDS reduction is the best indi-
cator of membrane performance. Please refer to the chart on page 14 for
replacement part numbers.
Post-filter
The post-filter will remove unwanted tastes and odors from the water. The
post-filter requires periodic replacement every 12 months after installation
to maintain VOC and Chloramine reduction. Your water quality and
water usage may affect this replacement schedule. Please refer to the chart
on page 14 for replacement part numbers.
4
!
Important Note: This Ultrefiner II System
contains replaceable treatment components,
critical for the effective reduction of total
dissolved solids (TDS). The product water
should be tested periodically to verify that the
system is performing properly. See your local
RainSoft Dealer for details.