Grounding Instructions; (Electric Ignition Models Only); Liquefied Petroleum (Propane); Gas Conversion - Frigidaire FGC6X7XESD Guide De L'utilisateur

Grounding Instructions

(electric ignition models only)

Avoid fire hazard or
electrical shock. Do not use an adaptor
plug, an extension cord, or remove
grounding prong from electrical power
cord. Failure to follow this warning can
cause serious injury, fire or death.
Liquefied Petroleum
(Propane) Gas
Conversion
Severe shock or damage
to the cooktop may occur if the cooktop
is not installed by a qualified installer or
electrician.

Flame Size

Never extend the flame beyond the outer
edge of the utensil. A higher flame simply
wastes heat and energy, and increases
your risk of being burned by the flame.
IMPORTANT: READ AND SAVE THESE INSTRUCTIONS.
protection against shock hazard and should be plugged directly into a properly
grounded receptacle. DO NOT cut or remove the grounding prong from this plug.
For personal safety, this cooktop must be properly grounded. For maximum
safety, the plug must be plugged into a 120V—60 Hz. outlet that is correctly
polarized and properly grounded.
If a two-prong wall receptacle is the only available outlet, it is the personal
responsibility of the consumer to have it replaced with a properly grounded three-
prong wall receptacle installed by a qualified electrician.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD ROUND
GROUNDING PRONG FROM THE POWER CORD PLUG. SEE THE INSTALLATION
INSTRUCTIONS PACKAGED WITH THIS COOKTOP FOR COMPLETE INSTALLATION
AND GROUNDING INSTRUCTIONS. DO NOT OPERATE THE COOKTOP USING A
TWO-PRONG ADAPTER OR AN EXTENSION CORD.
This appliance can be used with Natural Gas and Propane Gas. It is shipped from
the factory for use with natural gas.
If you wish to convert your cooktop for use with propane gas, use the supplied
fixed orifices located in the package containing the Installation Instructions, in a
bag marked "FOR LP/PROPANE GAS CONVERSION". Follow the instructions
packaged with the orifices.
The conversion must be performed by a qualified service technician in accordance
with the manufacturer's instructions and all codes and requirements of the
authority having jurisdiction. Failure to follow instructions could result in serious
injury or property damage. The qualified agency performing this work assumes
responsibility for the conversion.
For most cooking, start on the highest control setting and then turn to a lower
one to complete the process. Use the chart below as a guide for determining
proper flame size for various types of cooking. The size and type of utensil used
and the amount of food being cooked will influence the setting needed for
cooking.
For deep fat frying, use a thermometer and adjust the surface control knob
accordingly. If the fat is too cool, the food will absorb the fat and be greasy. If
the fat is too hot, the food will brown so quickly that the center will be
undercooked. Do not attempt to deep fat fry too much food at once as the food
will neither brown nor cook properly.
RIGHT
*Flame Size
High Flame
Medium Flame
Low Flame
WRONG
* These settings are based on using medium-weight aluminum pans with lids.
Settings may vary when using other types of pans.
This appliance is equipped with a 3 prong grounding plug for your
Type of Cooking
Start most foods; bring water to a boil; pan broiling
Maintain a slow boil; thicken sauces, gravies; steam
Keep foods cooking; poach; stew
5