Advice In Case Of Failure - Alice's Garden SIBERIA PC12KDSGYGC Mode D'emploi

EN

ADVICE IN CASE OF FAILURE

PROBLEM
The pilot light does
not turn on
The pilot light
does not stay lit
The burner does
not light
The flame of
burner is weak
Note : do not turn
on the device
when the tem-
perature is lower
than 5˚C
The flame of bur-
ner is not Uniform.
Note : the bottom
2.5 cm part of the
burner should not
have a flame.
Carbon accumu-
lation
Thick black smoke
36
REASON
The safety/reset button on the pressure
regulator has not been pushed.
The valve of the gas set point is closed /
Gas bottle is empty
The valve of the gas set point is closed /
Gas bottle is empty
There is air in the gas line
Gas pressure is low
The piezo igniter does not work
Accumulation of dirt around the pilot
light
The connection between the gas
valve and the pilot is loose
The thermocouple is not working
correctly.
Gas pressure is low
The orifice is blocked
The switch is not on
the «HI» or «LO» position
Gas pressure is low
Outside temperature
is greater than 5˚C and the cylinder
is ¼ full
The supply hose is folded or
twisted
The switch is not on
the «HI» or «LO» position
Gas pressure is low
The base is not on a flat surface
Accumulation of dirt on the burner
Dirt or cover on the reflector
and the transmitter
The burner is clogged
SOLUTION
Press the reset button on the regulator to
start the gas supply
Open valve / Replace set point - Pilot orifice
or tube is blocked
Clean the pilot orifice or tube with a brush or
using a brush or a paintbrush
Open and purge the gas line (keep the switch
pressed on PILOT) for 1 within 2 minutes or
until you detect a slight smell of gas
Replace the setpoint
Use a match to light the pilot light (next
page). If it lights up, get a new igniter and
replace it
Clean the dirt around the pilot light
Tightened the connection and check for
leaks
Replace the thermocouple
Replace the gas cylinder
Nettoyez l'orifice
Turn the button to the «ON» position
Replace the gas cylinder
Replace the gas cylinder
Untwist the hose and check there are no
leaks.
Turn the knob to the off position
(«OFF»), let the appliance cool down and
make sure that the burner and the orifices
are not blocked
Replace the gas cylinder
Place the heater on a levelled surface
Clean the burner.
Clean the reflector and the transmitter
Turn the knob to the off position
(«OFF»), let the appliance cool down,
remove the cover and clean the inside and
outside burner
6/07/2022