Aqua Marina BLUEDRIVE S POWER FIN Guide De L'utilisateur page 10

a. Insert the power cord of the charger into the corresponding hole position on the charger to
charge the control box.
b. Screw off the metal nut on the back of the control box counterclockwise;
c. Connect the metal plug on the charger to the corresponding connector on the control box
(Please note the direction of convex and concave corresponding position) and tighten the nut;
d. Plug the power plug of the charger into the home power supply.
e. Snap the magnetic switch in the right position of the control box. And the indicator light on the
charger will turn red when it is charging successfully. Please note: the control box can NOT
be charged when it is not connected with the magnetic switch.
f. The indicator light on the charger will turn solid green when the control box is fully charged.
After charging, remove the power plug and charger and keep them properly for next
charging.
3.1 Put the control box on the product with the
direction of metal plug towards the stern;
3.2 Fix the battery by fastening the elastic ropes
across the bottom of board respectively
and hook them on the 4 corners of control box.
4. The connection between the power fin and the control box: screw off the nut lid of the metal
plug on the control box, and insert the metal plug in the end of power line of the power fin
into the corresponding metal socket hole of the control box with correct direction and proper
inserting; and tighten the metal nut;
Metal plug towards the stern
10