Stamina 1215 Orbital Rower Manuel D'utilisation page 10

ASSEMBLY INSTRUCTIONS
STEP 7
Slide the SEAT(25) onto the CENTER BEAM(1). Insert the STOPPER WITH BOLT(20) through the CENTER
BEAM(1) and lock in position by screwing on the STOPPER WITH NUT(19). Also, please verify that the
other STOPPER WITH BOLT(20) and STOPPER WITH NUT(19) have already been assembled at the
factory. If it has not been pre-assembled, then please assemble at this time. Press the CENTER BEAM
CAP(28) into the back end of the CENTER BEAM(1).
STEP 8
Pry the METER(30) from the CONSOLE(31). Attach the CONSOLE(31) to the CENTER BEAM(1) with
ROUND HEAD SCREWS(M4x10mm)(48).
STEP 9
Install an AA battery into the METER(30), the battery is not included. See page 12 for detailed battery
installation instructions. Run the connection wire of the METER(30) through the square hole on the
CONSOLE(31). Place the METER(30) back into the CONSOLE(31). Plug the connection wire of the
METER(30) into the socket located at the front end of the CENTER BEAM(1).
SOCKET
(Assembled at the factory)
10