Hkoenig optiV8 Manuel D'instructions page 9

The air inside the filter has been pumped out. If these abnormal conditions continue happen for
more than 60 seconds, please check whether water tank and filter assembled correctly or not
C. When set selection button at "DRY" position, no steam escaped since it only just suits for
dry ironing.
Dry ironing
Connect the appliance to a suitable socket outlet, lay handle down. Power
1.
indicator light (red) on iron unit light up ,it indicates that the unit has been connected
to power supply.
Set selection button to desired position according to above fabric setting chart. Blue indicator
2.
light at iron unit blinks slowly to indicate the unit being heated up. When the blue indicator light
changes to light up steadily and an audible "Bi" signal produced, the desired temperature has
been reached. During use, blue indicator light will cycle from blinking to light on steadily, and then
from steady mode to On. lt does not indicate a defects or hazard, it is just because the appliance
is temperature constant.
After use, put iron unit back onto the base unit again, turn selection button to
3.
then unplug the appliance from main socket.
Note:
1.
When changing your Temp setting from higher setting to lower, it is proposed that not to
start ironing immediately since it may cause burns to your fabrics. Please wait till blue indicator
light lights up steadily, and then start ironing.
2.
This kind of iron has timing function. Press the steam button for 1 second at set
intervals abound 10 minute and the function will re-timing.
Application methods of vertical ironing:
Our special vertical ironing function makes the ironing for wrinkles on
hanging clothes curtains or wallpapers.
1. Setting the temperature at max gear, the iron can be used when
the indicator lamps lightened up.
2. Taking up the iron next to the cloth and pressing the steam button,
we can start to iron clothes.
Auto shut off function
If there are no actions has been made on the steam switch for about 15 minutes during use, the
iron will be power-off automatically, the temperature indicator light OFF and making a
'BEEP' sound 3 times. If u want to restart the iron, please press the temperature button again.
Auto-cleaning function
,and