NewAge Products BOLD 3.0 Mode D'emploi page 9

Mounting Locker
(Drywall/Studded Wall)
Use stud finder to locate the studs
1
and mark the wall with a pencil.
Place cabinet tight
3
against the wall.
Drill 6 wall screws and washers
6
through perforated holes into studs.
2
Align cabinet
4
to stud marks.
6x
Warning
Always secure locker to the wall.
Failure to do so can result in injury.
Gather parts.
5
Level cabinet
Masonry.
• Follow steps 1 to 5.
• Drill 6 pilot holes through the
perforated strip with hammer drill &
masonry bit.
• Use 6 x ( 2 ¼" x ¼" )Tapcon Concrete
Anchor into wall. (Not Included)
• OR 6 x (#10 x 2" )Screw with 3/ 1 6"
masonry plug into wall. (Not Included)
• Follow Step 6.
6x
Wall Screw
(1/4" x 21/2")
6x
Wall Washer
(1/4")