Sauder Carson Forge 412924 Mode D'emploi page 13

Step 8
First, fi ll the hole in the edge of each REAR LEG (I and J) 1/4 to 1/2 full with
å
GLUE (54M). Then, insert two WOOD DOWELS (15F) into the holes. Wipe away
the excess GLUE.
Now, fi ll the holes in the BACK SKIRT (M) 1/4 to 1/2 full with GLUE (54M). Then,
å
insert the WOOD DOWELS in the REAR LEGS (I and J) into these holes. Wipe
away the excess GLUE.
NOTE: Be sure the CAM SCREWS in the LEGS insert into the holes in the
å
SIDE SKIRTS (N).
Fasten the BACK (G), BRACE (H), and BACK SKIRT (M) to the ENDS (A and B),
å
REAR LEGS (I and J), and FRONT LEGS (K and L). Tighten eight HIDDEN CAMS.
54M
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely diffi cult.
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
www.sauder.com/services
I
A
K
Unfi nished edge
15F
Start
Arrow
S u r
f a c
e w
i t h
H I D
D E N
C A
M
M S
Rounded edge
Tighten
Maximum
210 degrees
Minimum
190 degrees
412924
Fill the holes 1/4 to 1/2 full with GLUE.
Edge with
HIDDEN CAMS
G
H
J
L
Arrow
B
Page 13