Technical Data - Beper VE.111 Manuel D'instructions

Stand Fan Use instructions
HEAD INCLINATION
It is possible to choose various positions and change the air flow swing.
Before changing it, switch off the fan.
Take the motor body, unscrew the regulation axis and change the inclination of the fan as desired
and screw the air strongly.
Attention : do not try to force the inclination position in order to avoid any failure.
SWING
It is possible to activate or disconnect the swing of the fan, by touching the swing axis (8). Swing
allow to provide the air uniformly.
To activate the push the swig axis (8) down until completely blocked ; the head fan turns automati-
cally from right to left.
To disconnect the swing raise completely the axis (8).
CLEANING
Before cleaning, switch off and unplug the fan.
For cleaning use a soft cloth, that may be softly wet.
Do not use alcohol or chemical substances, or any detergent that could damaged this appliance.
Do not flush water or other liquids on the fan in order to protect it.
After cleaning, dry every parts before using the appliance.
During the winter and when not used, keep this appliance in a dry and clean place.

TECHNICAL DATA

Power : 50W
Power supply. 230V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment. The crossed out "wheeled bin" symbol on the product
reminds you of your obligation, that when you dispose of the appliance, it must be separa-
tely collected.
12