Mistral EVOPURE Manuel D'installation page 15

Option Anti-leackage system: WaterBlock® / Watersafe®
For Waterslock® :
1. Turn off the water supply
2. Connect WaterSafe® to water supply (hand tightening);
3. Connect the WaterSafe® power cable to the RJ9 plug-in, located
to the cooler's back, near the water in let.
4. Connect the WaterSafe® tube to the water cooler inlet.
5. System is ready to use - Turn on the water supply.
MAINTENANCE : Check the filter's cleaning at the Watersafe®'s en-
trance.
The use of the Watersafe® is highly recommended to avoid any
consequences of a leak from the water cooler.
Water drip tray - Left indicator light
MAINTENANCE
For Waterblock: Turn off the water supply. Press the buttons to empty the water
pres sure inside the circuit. Screw the water block (1) (by hand).
Connect the blue 1/4 tube on the water block (2) and turn on the water supply.
Waterblock® does not guarantee an effective protection
against water leaks lower than 2 liters per minute.
The water cooler includes a system that indicates, by an indicator
light, that the drip tray is filled up.
WARNING : Please note that when the drip tray is filled up, the
contrai panel doesn't work anymore.
The drip tray is equiped with a sensor (1) that is launched when it gets in
contact with water.
To unjam the water cooler, empty the drip tray of water.
Clean and dry the drip tray.
15