TecTake 403581 Mode D'emploi page 6

Symptoms
After connecting the
power and pressing the
"power" key, the
appliance has no
response.
Heating being
interrupted in normal
use and a "Beep" will
be heard.
No operation during the
heating being in use.
Error codes occur.
If the above remedies/controls can not fix the problem, unplug the appliance immediately,
contact service Centre for inspection and repairing, note the error code and report it to Service
Centre Ltd.
To avoid any danger and damage to the appliance, do not disassemble or repair it by yourself.
Check points
Is the electricity in suspension?
Is the fuse broken down?
Is the plug connected firmly?
Incompatible cookware or no
cookware is used?
Is the cookware not considerably
placed form the center of the heating
zone?
Is the cookware being heated but
continually being removed?
Is the cookware empty or the
temperature too high?
Is the air intake/exhaust vent clogged
or dirt has accumulated?
Is the cooker working over 2 hours
without any external instruction?
E0 Internal circuit error
E1 Without cookware or Incompatible
cookware used
E2 Internal overheat
E3 Over-voltage
E4 Under-Voltage
E5 Top plate sensor open/short circuit
E6 IGBT sensor open circuit/short
circuit
E7 Top plate overheat
Remedy
Use after resuming the
electricity.
Check the root causes
carefully. If the problem
cannot be fixed, please contact
Service Centre for checking
and repairing.
Replace compatible cookware
for the induction cooker.
Place the cookware at the
center of the defined heating
zone.
Place a cookware inside the
heating zone.
Please check whether the
appliance is being misused.
Remove the stuff clogging the
air intake/exhaust vent.
Operate the appliance again
after cooling down.
Reset cooking modes or use
timer function.
When showing error signal E1,
E2 and E7, please check
whether the cookware is not
suitable, or switch on the
appliance again after it is
cooled down naturally. When
showing E0, E3-E6, please
contact Service Centre for
checking and repairing.
6