afriso CosiTherm F2A Notice Technique page 89

6.2.5 Terminating
1. Refit the cover of the product and close it.
2. Install the room temperature sensors "FT / FTF" in the appropriate
rooms. Observe the assignment room temperature sensor/control cir-
cuit/room when doing so.
6.3 Function test
Room temperature sensor "FT / FTF"
Verify that the room temperature is between +15 °C and +25 °C. Test the
room temperature sensors "FT / FTF" one after another.
1. Verify that the room temperature sensor to be tested is connected to the
correct control circuit.
2. Set the room temperature sensor to +30 °C.
- After one minute, the yellow LED lights up at the controller module to
which the room temperature sensor is connected.
3. Repeat this procedure for all other room temperature sensors.
Commissioning
F2A / F6A
EN
25