Publicité
Les langues disponibles
Les langues disponibles
5.3
Mounting modules on a DIN rail
Verify that all modules (base module and controller modules) are plugged
together and firmly locked.
Verify that all cables are connected.
Mounting
B
B
2. Repeat this procedure for all other
cables.
3. It is possible to open the cable
clamps. To do so, pull the two tabs
(B) outwards and remove the
cable clamp.
1. Fit the modules (base module and
controller module) onto the DIN
rail with the upper clamps.
2. Push the lower end of the mod-
ules (base module and controller
module) towards the DIN rail until
they snap in with a click.
F2A / F6A
EN
17
Publicité
