Publicité
Les langues disponibles
Les langues disponibles
6.2.3
Clear/reset
Commissioning
4. Proceed as described above.
Once you have taught in all control
circuits (1 to 2, or 1 to 6) of a product,
the product switches back to normal
operating mode.
If you do not press the LRN key of a
room temperature sensor "FT / FTF"
in LRN mode (the yellow control cir-
cuit LED flashes at intervals of one
second) for a period of 30 seconds,
the product automatically switches
back to normal operating mode.
1. Press the CLR key of the product
with the tip of the ballpoint pen (for
at least two seconds) until the yel-
low LED for control circuit 1 starts
flashing.
- All taught-in room temperature
sensors "FT / FTF" of this prod-
uct have been cleared.
- The product is again in teach-in
mode.
F2A / F6A
EN
22
Publicité
