How To Install - TAD ST2TX Mode D'emploi

How to install

This unit comes with a spike, spike holder, non-slip cork sheet,
and a spike to prevent the unit from tipping over, allowing you
to choose the best installation method for the surface you want
to install it on. Please refer to the following to determine the
best installation method.
Spikes Installation location
Cone-shaped Locations with thick
carpet, floors where no
spikes
marks will be caused
or scars do not matter.
28 mm
Flat surface
Flat surface
Use no spikes
Using the spikes
• The speaker stands include spikes that you can use to isolate
the speaker from the floor. Spikes are recommended when
placing the stand on a thick carpet (for added stability), or for
better sound when placing the stand on a hard reverberant
surface (such as a concrete or wood floor). Use the supplied
spike bases to avoid scratching the floor or other surface
where the stand is placed.
1. Screw the spikes into the three locations indicated on the bot-
tom of the stand base.
2. Adjust the length of the auxiliary support feet as required to
correct any uneven floor contact, then tighten using the hex
nuts.
Stand base plate
Application
Press spikes into carpet.
Carpet
In order to prevent marks
on the floor, use the spike
bases provided.
Apply the non-slip cork
pads to the three locations
indicated in the illustration
Stand base plate
Non-slip cork pads
Caution
' Note that these spikes are sharp metal and can cause
damage to flooring. Make sure to lay down a cloth or suitable
base before setting up.
' The spike bases should be placed as shown below (with the
depression on the top side).
' Make sure to use the spike bases provided to avoid
damaging the surface where you place the stand.
Attaching speakers TAD-CE1TX to the stands
To avoid accident or injury, please use screws to secure the
speakers to the speaker stands.
1. Place the TAD-CE1TX speaker on the top panel and secure with
screws (bind head, M5 x L30, with washers).
Nuts for securing the speaker to the speaker support plate
are embedded in the bottom surface of the speaker.
Speaker support
Do not attempt to fasten this speaker stand to any object
other than the TAD-CE1TX speaker system for which it was
designed, since uneven balance may cause the object to fall,
resulting in personal injury.
Screw holes for
securing speaker
(2 positions)
Screws (Bind head, M5 x L30)
[3-939030-039899]
3