Before You Start; Important - TAD ST2TX Mode D'emploi

Thank you for buying this TAD product. The TAD-ST2TX is a
speaker stand exclusively designed for use with the TAD-CE1TX
speaker system.
Please read through these operating instructions for proper
assembly and use. After you have finished reading the
instructions, put them away in a safe place for future reference.

Before you start

Before setting up your speaker system, we recommend reading
the operating instructions for your system thoroughly:
Caution
' Only use the screws supplied when fixing the speaker to the
speaker stand.
' Do not place the stand on an unstable and/or sloping
surface. The stand and speaker may fall and cause injury.
' Do not attempt to use this stand to support any object
other than the TAD-CE1TX speaker system for which it was
designed. The stand may collapse and be damaged and/or
the speaker may fall and cause injury.
' When moving the speaker and stand, first remove the
speaker from the stand, and then move the stand, holding it
by the stem.
Installing the speaker stands
Place the stand on a stable, level surface; placing the stand on
an unstable surface can be dangerous.

Important

' TAD assumes no liability whatsoever for damages
resulting from assembly, improper mounting, insufficient
reinforcement, misuse of the product, acts of nature, etc.
2
Assembling the speaker stands
Assemble the speaker stands as illustrated below. Please note
that a Phillips screwdriver will be necessary for assembly. The
following illustration shows the fully assembled speaker stand:
Speaker support
Stand stems
Stand base
' Align the screw holes on the stand base and speaker
support with the screw holes in the stem, then insert
the screws and tighten.
Speaker support
※ The notched side
is the front side.
Stand stems
Stand base
Screws
(Bind head, M6 x L28)
[3-939030-034035]
Spike base
[3-939051-030274]
* The illustration here depicts the speaker stand when
equipped with cone-shaped spikes (type b).
Caution
' Make sure you assemble the stand on a flat surface that is
relatively soft (such as a carpet).
' Make sure the screws are inserted in the screw holes as
shown above (with the screw head hidden) when securing
the speaker. Improper setup could result in damage or injury
if the speaker falls from the stand.
Screw holes for
securing speaker
(2 positions)
Screws (Bind head, M6 x L28)
[3-939030-034035]
Note that the speaker support plate is
provided with countersunk screw holes.
Orientation of Support Pillar
Front side
Be careful of the orientation of the
support columns when assembling.
Auxiliary support feet, with
hex nuts
[3-939009-039901]
Spikes
[3-939009-039900]