Black & Decker BDCS40G Manuel D'instructions page 8

VARIABLE SPEED
• The spindle speed is dependent upon the speed that you rotate your hand.
• The slower you rotate your hand, the slower the screwdriver turns.
• The faster you rotate your hand, the faster the screwdriver turns.
• If you wish to increase the spindle speed, rotate your hand further in the same direction.
• If you wish to decrease the spindle speed, rotate your hand back towards the initial starting point.
GYRO CONTROL CALIBRATION
This unit automatically re-calibrates itself periodically to ensure proper operation of the
motion-based gyro controls. In the event that the unit controls appear to be acting
improperly, the unit can be re-calibrated by pressing the motion control activator button,
releasing, and letting it rest completely still on a level surface. The LED will flash twice
within 5 seconds to indicate that the unit has been successfully re-calibrated.
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
BATTERY REMOVAL AND DISPOSAL
This product uses lithium-ion rechargeable and recyclable batteries. When the batteries
no longer hold a charge, they should be removed from the product and recycled. They
must not be incinerated or composited.
The batteries can be taken for disposal to a Black & Decker, Company-Owned or
Authorized Service Center. Some local retailers are also participating in a national
recycling program (see "RBRC
the batteries to a Black & Decker Company-Owned or Authorized Service Center, the
Center will arrange to recycle old batteries. Or, contact your local municipality for proper
disposal instructions in your city/town.
To remove the battery pack for disposal: 1.) First, before attempting to disassemble the product, turn it on and run it in either
direction until it stops to ensure a complete discharge of the batteries.
2.) Remove the screws in the product housing and lift the housing half from the tool.
3.) Disconnect the terminal clips from the batteries and lift the batteries out.
4.) Place the battery in suitable packaging to prevent a short circuit of the battery
terminals.
5.) Dispose of batteries as per recommended guidelines.
All manuals and user guides at all-guides.com
MAINTENANCE
Seal"). Call your local retailer for details. If you bring
TM
8