Application; Application Range; General Information - Solo 69 00 227 Instructions D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fig. 6
To separate the shaft sections:
Release the straining screw (1).
Pull out the fixing pin (2).
Pull the lower shaft tube (3) with gearbox
from the female coupling.
When assembling ensure that the hollow shaft
in the lower shaft tube mates with the quadrant
in the upper part of the drive shaft. When
assembling it may be necessary to lightly jiggle
the lower shaft tube. The fixing pin (2) must
audibly lock into position in the shaft tube
holes.
Ten tighten the straining screw (1).
Tip: The holes on both sides enables the lower
shaft tube to be attached either way, i.e. turned
through 180°. This is of particular advantage if
hedge trimming above head height.
Note: The following SOLO spare parts are
designed especially for use with the brushcutter
SOLO 129LTS with sectional shaft:
Shaft tube extension (SOLO part no. 69 00
608, extension of about 800 mm) for a very
long reach.
Extra short lower shaft tube (SOLO part no.
69 00 265, approx. 210 mm) for close work.
Preparation for work – Installation; Application
C) General fitting information for both
types
Fig. 7
The desired cutting blade angle can be attained
by releasing the cutting edge angle straining
screw (6). Always set the desired angle via the
pivoting lever (7). Never touch the blades when
setting the cutting blade angle. Tighten the
cutting edge angle straining screw (6).
Tip: Some users find it particularly useful that
the loop handle on the SOLO brushcutter can
easily be turned by 90° on the shaft tube due to
the tensioning toggle.

7. Application

7.1 Application range

Hedge trimmer attachments, attached to
approved brushcutters may only be used to cut
hedges, shrubs, undergrowth and brush with
slender twigs and branches. The use of this tool
for any other application is not permitted – risk
of accidents.

7.2 General Information

Never operate in the slipping range of the
clutch.
Before use, remove thicker branches and
twigs with lopping shears.
Where there is stronger growth, work in
stages lopping off the stronger branches and
twigs as you go.
ENGLISH
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

69 00 228

Table des Matières