Description; Installation; Overhead Rigging; Dmx512 Connection - Iridium Stage Panel Light 200W DMX RGBWW Mode D'emploi

- DMX controlled operation, possible work with any commercial DMX512 controller
This device can be mounted in many orientations provided each individual device is secured by the use of correct
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for 1hour
without any harming deformation. The installation must always be secured with a secondary safety attachment. This
secondary safety attachment must be constructed in a way that no part of the installation can fall down if the main
attachment fails. The operator has to make sure that safety-relating and machine-technical installations are approved
by an expert and before taking into operation for the first time and after changes .
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be followed that
If you are using controllers with this occupation, you can connect the DMX output of the controller directly with the
Building a serial DMX chain: Connect the DMX output of the first fixture in the DMX chain with the DMX input of the
next fixture. Always connect one output with the input of the next fixture until all fixtures are connected.
For better signal receival, a signal amplifier suggest to be used for each 20 fixtures.
This device has an auto-switching power supply work with input voltage range of 100-230V AC, 50/60Hz. Link up to

3. Description

- Material material, good performance of cooling system
- Ultra slim
- Different dimmer curves and dimmer speed adjustable
- Flicker free projection
- Color filter optional
- Ready for connection with power cord with safety-plug

4. Installation

mounting bracket.

Overhead rigging

this manual can only give in part.

DMX512 connection

DMX input of the first fixture in the DMX chain.

Power input

5