Introduction; Safety Instructions; Proper Use; Care - Iridium Stage Panel Light 200W DMX RGBWW Mode D'emploi

Dear customer, thank you for deciding to purchase our product. The product fulfils the requirements of effective
European and national guidelines. To maintain the condition of the product and to ensure safe operation, you - as the
They contain important information for the start-up and handling. It is important, therefore, that these documents are
We are not responsible for any property damage or personal injury caused by failure to observe these product notes
It can only be installed by a qualified electrician. Make sure that the item has not been damaged during transport
before putting the light into operation. It may not be operated if there are any damages to electrical parts. The
luminaire may only be operated completely with its protective cover. It may only be operated once removed from the
The connection lines in the building must be disconnected before installation and secured against being switched
Make sure the electrical specifications for the connection lines correspond with the specifications given on the
nameplate of this product. We recommend that you protect the product with a residual-current-operated protective
Follow all installation regulations applicable at your location. Make sure that the cables and plugs are not subject to
tension or torsional forces and do not bend the cables. Protect all cables and insulation against possible damages.
Output lines should be laid separately and spaced apart from other lines. The power supply cables and the lamp
feeders must not cross each other. Do not allow the product to come into contact with extreme heat or naked flames.
Use the supplied fastening material only when it is suited for the installation background. The product must not
be covered with objects (decorations) or thermally insulating coverings /similar materials. Before disposal of the
packaging material make sure that all components are removed. Keep packaging material away from the reach of
children and pets. The packaging contains small parts that may be swallowed by children.
This product is only intended for lighting purposes and may only be operated on normal or non-flammable surfaces.
Make sure that the surface is suitable for permanently and reliably taking the weight of the light.
Repairs may only be carried out by a qualified electrician. If the external flexible cable or cord of this luminaire is
damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in
order to avoid a hazard. Disconnect the entire product from the mains first and allow it to cool down before cleaning
or maintaining. Use a dry or slightly moistened cloth for cleaning. Never use any chemicals, flammable cleaning
agents or abrasives. These may cause damage to the surface coating and/or the insulators.
4
user - must observe the product notes and the operation manual!
archived carefully for referring to information at a later stage.
and manual, improper handling or unauthorised modifications.
packaging. The type plate must not be removed.
back on. For this, trip the corresponding fuse switch in the building installation.
The use can be done in indoor/outdoor areas.

1. Introduction

2. Safety Instructions

device.

Proper Use

Care