Red Sea REEF-SPEC MAX NANO Mode D'emploi page 18

Red Sea MAX ® NANO
8 Installation of LED Modules
The ReefLED 50 for the MAX
®
by a swivel joint. The mounting arm is attached to the aquarium by the
hole provided for it in the top of the Pump Switch-box The complete LED
assembly can be rotated from side to side for ease of aquascaping and
maintenance of the rear sump, specifically when removing the skimmer.
1. Using the M3 screws provided,
attach the swivel connector as
shown in the diagram
2. Push the swivel connector on the
ReefLED onto the arm extension.
Insert the connector pins to both
sides and push until firmly in
position. Screw the fixing screw
into the top of the connector until
the ReefLED is secure.
3. Thread the cable through
the hole in the bend of the
mounting arm and push the
cable-hole plug into position.
14
NANO is attached to the mounting arm
®
4. To attach the LED mounting
arm to the switchbox hold it
so that the pin at the bottom
of the arm is over the hole
in the switchbox and the LED
unit is facing sideways as
shown in the diagram. Place
the cable over the back of
the aquarium.
5. Lower the pin into the hole
and when the flat part on
the arm is in resting on the
Pump Switch Box, rotate the
arm to the forward position.
Thread the cable through the
recess provided in the back of
the Pump Switch Box. Un-
tighten the fixing screw on the
top of the swivel connector.
Adjust the position of the
ReefLED until it is parallel with
the top of the aquarium and re-
tighten the fixing screw.
Find a suitable safe place to
locate the power supply, such as
in the cabinet.