Safety Warnings; User Manual - PNI SVM1000VA Manuel Utilisateur

Safety warnings

Read the warnings below carefully before putting the device into
operation.
• Keep the device in a clean and well-ventilated environment,
at least 100 mm from the wall or other objects. During
operation, the surface temperature of the device could
reach 50°C.
• Do not open the device housing to avoid the risk of short
circuit.
• Do not spill liquid on the device. Risk of short circuit.
• Do not store or use the device in the following conditions: in
places with flammable or corrosive gases, in places with a lot
of dust, in places where the temperature exceeds +80°C or
drops below -26°C and the humidity exceeds 90%, under
direct beating the sun or near heat sources.
• Do not allow children to enter near the stabilizer.
• The stabilizer must be supplied from a grounded source.
• In case of fire, do not use water but only fire extinguishers.
• Do not connect consumers with loads that exceed the power
of the stabilizer. For example, motor/compressor electronics
can start 2-6 times more than the declared power. Choose
the stabilizer, taking this into account.
Introduction
The PNI Voltage stabilizers with servomotor have been designed
to keep the input voltage as stable as possible. When the voltage
from the public network fluctuates, the stabilizer will
automatically adjust the voltage as close as possible to the preset
value (230V).

User manual - 3