Swagman Race Ready Guide D'assemblage page 6

9. Unscrew the 4 bolts holding the unit onto the extrusion.
9
10. Turn the unit upside down and remove the two bolts
holding the aluminum shaft into the plastic mount.
10
11. Slide the aluminum shaft so it aligns up with the two
holes on the opposite end of the shaft.
11
12. Re-install the two bolts previously removed and tighten.
12
Swagman • 300 - 1880 Government St. • Penticton, B.C. Canada V2A 7J1 • Phone (250) 490-8883 • Fax (250) 490-8885 • www.swagman.net
PRODUCT: 64705 Race Ready • Page 2 of 3
INSTRUCTION SHEET
13. Re-install the bracket back onto the aluminum
extrusion.
13
14. Install the wheel cage holders.
14
15. Re-install the two screws to hold on the wheel cage.
15
16. Slide on the plastic shim.
16
REV 05/20/20