Linx
Contents
1 Introduction
Safety Information
2 Key Points
3 Transport and Storage
4 Battery Charging
Battery Safety
Linx contains Li-Ion type rechargeable batteries. Please read and comply with the
safety information see Section 4. Failure to do so may cause the battery to become hot,
explode, or ignite and cause serious injury.
IMPORTANT: Battery Charging
Linx has an On/Off Switch which must be in the ON position to
ensure that the Linx battery is being charged.
If Linx is charging the Battery Charger LED will be flashing
green.
The battery should only be charged within the temperature
range 10 ˚C to 40 ˚C (50 ˚F to 104 ˚F).
Low Temperature operation
IMPORTANT:
If the limb is subjected to temperatures lower than -10°C ( 14°F) it must be returned to
be inspected for possible damage to the battery pack.
Following extended periods of inactivity at temperatures below 0°C (32°F) the limb
may swing less freely. In such an eventuality, it is recommended to exercise caution
while descending stairs and avoid descending stairs leg-over-leg using the knee yield
until you feel the swing returns to normal.
Notes:
1. The Linx firmware has been updated. To check which version of the Linx firmware
is installed on your device, reset the device. If your device emits 2 short beeps
30 seconds after turning on, it is installed with version 1.0N or higher of the Linx
firmware.
2. This symbol represents information that only applies to devices with version 1.0N
or higher of the Linx firmware:
3. This symbol represents information that only applies to devices with version 1.0B
or lower of the Linx firmware:
User Guide
1.0N+
1.0B
1
EN
Battery On/Off Switch
938354S/1-0618