Sauder 416368 Mode D'emploi page 9

Step 6
Carefully turn your unit over onto its front edges. Lay the
å
DESK BACK (H) over your unit.
Make equal margins along all four edges of the DESK
å
BACK (H). Push on opposite corners of your unit if needed
to make it "square".
Fasten the DESK BACK (H) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the DESK SHELF (G).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
This hole must be closer
to the bottom edge.
NAIL
(20 used in this step)
www.sauder.com/services
These holes must line up
over the DESK SHELF (G).
H
1N
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
416368 Page 9