BGS technic 68345 Mode D'emploi page 5

OPERATION
FSI-Engines
to disassemble the
puller barrel injectors,
to be used as T10133/1
to disassemble the
puller claw injectors,
to be used as T10133/2
to disassemble the
gliding
injectors,
hammer
to be used as T10133/3
to mount the combustion
assembly
chamber sealing rings,
cone
to be used as T10133/5
for pushing the
calibrating combustion chamber
barrel sealing rings,
to use as T10133/6
1st step
for narrowing the
calibrating
combustion chamber
barrel
sealing rings
to be used as T10133/7
2nd step
for narrowing the
calibrating
combustion chamber
barrel
sealing rings,
to be used as T10133/8
to mount the fuel
fitting pin injectors,
to be used as T10133/9
Caution:
•
Combustion chamber sealing ring set up without using of oil.
•
By mounting the sealing rings on the assembly cone this to be expanded.
After assembly, combustion chamber sealing rings must therefore be
narrowed in two steps with the calibrating barrel again.
•
This manual is only to show how to operate with this tool and it is not replace
the service literature. For repair, adjustment and inspection work always use
appropriate service literature, so you avoid erroneous diagnoses and incorrect
settings that can lead to engine damage
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed