Axis M11 Serie Guide D'installation page 13

NO TICE TICE
NO NO TICE
The product shall be connected using a shielded network cable
(STP). All cables connecting the product to the network shall
be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's
instructions. For information about regulatory requirements, see
Electromagnetic Compatibility (EMC) on page 2.
I/O Connector
Use with external devices in combination with, for example, tampering
alarms, motion detection, event triggering, time lapse recording and alarm
notifications. In addition to the 0 V DC reference point and power (DC
output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays
and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface, output buttons on the
Live View page or by an Action Rule. The output will show as
active (shown under System Options > Ports & Devices) if
the alarm device is activated.
• Digital input – An alarm input for connecting devices that
can toggle between an open and closed circuit, for example:
PIRs, door/window contacts, glass break detectors, etc. When
a signal is received the state changes and the input becomes
active (shown under System Options > Ports & Devices).
Power Connector
2-pin terminal block for power input. Use a Safety Extra Low Voltage
(SELV) compliant limited power source (LPS) with either a rated output
power limited to ≤100 W or a rated output current limited to ≤5 A.
SD Card Slot
For SD card recommendations, see www.axis.com
AXIS M11 Network Camera Series
13