Safety; Explanation Of Symbols; Personnel Requirements; Notes To Personnel - Reflex Exdirt magneto Mode D'emploi

Safety

1 Safety
1.1

Explanation of symbols

The following symbols and signal words are used in this operating manual.
DANGER
Danger of death and/or serious damage to health
• The sign, in combination with the signal word "Danger", indicates imminent danger; failure to observe the safety information will
result in death or severe (irreversible) injuries.
WARNING
Serious damage to health
• The sign, in combination with the signal word "Warning", indicates imminent danger; failure to observe the safety information can
result in death or severe (irreversible) injuries.
CAUTION
Damage to health
• The sign, in combination with the signal word "Caution", indicates danger; failure to observe the safety information can result in
minor (reversible) injuries.
ATTENTION
Damage to property
• The sign, in combination with the signal word "Attention", indicates a situation where damage to the product itself or objects
within its vicinity can occur.
Note!
This symbol, in combination with the signal word "Note", indicates useful tips and recommendations regarding the
efficient use of the product.
1.2

Personnel requirements

Only specialist personnel or specifically trained personnel may install and operate the equipment.
Regional regulations and directives must be adhered to.
1.3

Notes to personnel

Note!
Every person installing this equipment or performing any other work at the equipment is required to carefully read this
manual prior to commencing work and to comply with its instructions. The manual is to be provided to the device
operator and must be stored near the device for access at any time.
• Modifications of the equipment are not permitted.
• For example, welding at other points than the connection piece (in equipment with welded connection)
• For example, mechanical deformations
• Use only original parts provided by the manufacturer when replacing parts.
• All required inspections must be ordered by the operator pursuant to the provisions of the applicable industrial safety regulations.
Required inspections and tests are:
• Inspections and tests prior to commissioning
• Inspections and tests after significant modifications of the installation
• Recurring inspections
• The devices to be installed and operated must not exhibit any visible exterior damage at the pressure component.
• Ignoring this manual and the safety information in particular, may cause the destruction and defects of the equipment, endanger
persons and adversely affect the functioning. Any contravention voids the guarantee and liability.
4 — English Exdirt magneto — 19.06.2017