Teka HLC 844 C Guide D'utilisation page 12

3. Turn the control dial to position
4. Set the temperature to 90º C.
5. Program a duration of 4 minutes on the
timer.
6. After 4 minutes, an alarm will sound and
the oven will stop heating.
7. Turn the control dial to position
8. Wait for about 20 minutes for the interior
of the oven to cool.
Do not open the oven until the cooling
phase is complete.
This is necessary for the Hydroclean
function to work properly.
12
9. Any traces of dirt and excess water can
.
now be removed from the oven with the
damp cloth.
The Hydroclean
temperature. However, cooling times can
vary depending on the room temperature.
.
Before touching the inside surface of the
oven, make sure that it has cooled
properly.
If a deeper clean is required after using the
Hydroclean
and non-abrasive sponges.
®
®
function takes place at a low
®
function, use neutral detergents