Dometic FreshWell2000 Instructions De Montage page 12

Installation
Note on electrical system (see fig. b)
No. in fig. b Description
1 Motor ventilator (inner)
2 Motor ventilator (outer)
3 Capacitor
4 Compressor
5 Temperature sensor
6 PCB
7 PCB Display
 Only a qualified electrician should connect the under-bench air condi-
tioner to the electrical power.
 Check that the voltage specification on the type plate is the same as that
of the power supply.
 Do not lay cables which are loose or bent next to electrically conductive
material (metal).
 Install an all-pole switch with a contact opening width of at least 3 mm on
the installation side.
7.2 Making openings
See fig. 3
➤ Mark the position and size of the openings using the template included in
the packaging (A and B).
See fig. 4
➤ Drill out the corners (A).
➤ Carefully cut out the opening on the roof using a keyhole saw or a similar
tool (B).
Make sure no electrical power cables are damaged.
➤ Drill out a condensation water drainage opening with a diameter of
32 mm (C).
See fig. 5
➤ Mark the position of the angle sections (A) and the fastening brackets (B).
10
FreshWell2000
EN